
50 UG034, July 1, 2014
Digilent connector (J29)
You can use the Digilent connector (J29) to expand the functionality of the board. This is a
standard right-angle 1x6 Molex connector. Figure 11 shows the connector and Table 17 shows
the connections to the relevant pins on the HD1000.
Table 17: Digilent Connector and Connection to HD1000 Pins
Jumpers
There are several jumpers on the board for configuration, signal selection, I
2
C master
selection, and other such functions. You can find more information about these in LEDS,
Buttons, Jumpers, and Switches chapter.
LEDs
There are 12 LEDs on the board. Some of these are dedicated to provide status information.
Others are user-programmable. You can find more information about these in LEDS,
Buttons, Jumpers, and Switches chapter.
Switches
You can use the push button switch (S3) to reset the MCU on the board. You can use the bank
of 8 dip switches (SW7) to select the configuration mode signal levels on the HD1000 as
shown in Figure 2. Table 18 shows the signal names and the relevant pins on the HD1000 and
their connections to the switch.
Table 18: Configuration Signal Pins for the HD1000 and their Connections
Comentarios a estos manuales